Skysens Temperature/Humidity + Probe

Owned by Brent Meriwether (Unlicensed)
Aug 13, 2021
1 min read

Activation

  1. Connect the antenna and probe to the sensor. The status indicator will briefly change to red. The sensor device will then attempt to connect with your gateway.

  2. After a few moments the status indicator should change to green indicating that the device is connected and ready for use.

Reset

In the event your device is offline or you need to reset it, please follow these steps.

  1. Insert a paperclip into the hole located on the side of the sensor until the status indicator flashes red.

  2. After a few moments the status indicator should change to green indicating that the device is connected to your gateway.