Turning On Device
To power the device ON, remove the cover of the enLink Status by unscrewing the two screws on the cover.
Locate the power switch and using small screwdriver gently slide the power switch towards the ON position as shown.
Switch to the ON position
Once powered ON, the enLink device will send a Join request message to the LoRaWAN network server. The Mode LED will blink RED as shown below whilst the Join process is taking place. Depending on factors such as signal strength, RF interference etc. the join process may take several seconds to complete.
Blinking Red LED – Attempting Join
When the device has successfully joined the network the Status LED will blink GREEN five times to show that the join has been completed. The LED’s will then switch off to conserve the batteries.
Blinking Green LED – Device Successfully Joined
Calibrating Device
Install Devices
Unplug both tubes
Let device run for 2-3 hours
Take the average of the data collected to create a baseline
Enter average in Device Settings to calibrate