Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Next »

Mounting, Turning On & Configuring Device

  1. https://player.vimeo.com/video/877660695 Mount sensor where applicable close to a power outlet (as this is powered by a 12V power adapter that will be provided) https://player.vimeo.com/video/877661991  

  1. This is a Wifi Enabled device, after mounting, get off the current wifi network, go onto the People Counter wifi (SSID People Counter_XXXXXX. EX: People Counter_F7D7D2)(This is on the bottom side of the device)

  2. Accessing the Sensor: Web GUI https://player.vimeo.com/video/877665781  

    1. Once the LED light is BLUE (go to step B)

    2. On Web Browser, login to 192.168.1.1

    3. Set your Password and the Security Questions of your choice.

    4. To change The Password and Security Questions, please navigate to the SYSTEM tab. USERS MODIFY: Resets Password SECURITY QUESTIONS: Reset Security Questions.

  1. For the Installation Height, navigate to the RULES tab under Deployment Parameters, set the correct height, measure with a measuring stick, and set that in Milimeter

  2. Once the height is accurate, the Counter is ready to use.

Enabling Dwell Detection

STEP 1

Connect to the VS133 Local WiFi. (Remember to be off local wifi to be able to connect to the devices wifi)

STEP 2

Navigate to Rules (Second tab when you log-in to Web UI)

STEP 3

On the Right side of the screen, you will see where it says Counting Strategy. Underneath that you will see where it says Region Monitoring, Please turn that on.

STEP 4

After turning on Region Monitoring, Navigate back to the image of the device, and draw the lines where you would like to detect. Then Click the blue check mark in the dialogue box to save the changes you made.

STEP 5

The Advanced Properties dialog will pop up after saving. In the Advanced Properties dialog box is where you can enable the Dwell Time Detection. Click on blue check mark in dialogue box to save the changes that you have just set. Save again and you’re done.

  • No labels