Milesight VS133-P

Owned by Shant Aposhian
Mar 11, 2024
3 min read

  1. Once you login to the IP Address 192.168.5.220, it will bring you to the start of the page. I have gone ahead and changed this to DHCP.

  1. After signing in, it will bring you to the dashboard where you can see the Total In, Total Out, and Capacity. It also gives you the option to Reset Count and Digital Output. It also shows the Time & Date.

  2. On the left side of the screen, you will see the Accessible fields, Dashboard, Rule, Communication, Report, Validation, and System

  3. The Rule tab gives access to review the Working Mode, Deployment Parameters and Counting Strategy

  4. The Communication tab is how you would like the device to connect to the network, by default it was on 192.168.5.220 but I have changed that to work with DHCP.

  5. The Report tab is where you can see the events of Line Crossing Counting, Region People Counting, Dwell Time Detection, and Heat Map. You can also access the Time Unit to how you would like to see the events: Hourly, Daily or  Monthly.

  6. The Validation tab shows the Recording Tasks and the Counting Data.  

     

  7. The last tab, System, shows the Device Information, Users, Current System Time and  Synchronize Time.

     

  8. In the System tab you can also access Remote Management, Time of Flight Advanced Settings, Reset, Upgrade and Backup and Restore.