Netvox PM2.5/Temperature/Humidity (RA0716)

Open

Activation

1. Connect power to the sensor.

2. The status indicator will briefly flash green. The sensor device will then attempt to connect with your gateway.

3. After a few moments the status indicator should change briefly to solid green indicating that the device is connected and ready for use.

4. Verify successful connection by sending a sensor reading. Press the button on the side of the sensor device. The status indicator should briefly flash green.

Reset

In the event your device is offline or you need to reset it, please follow these steps.

1. Press and hold the button on the side of the sensor until the status indicator flashes green.

2. Disconnect and reconnect the power from the sensor.

3. Follow the activation instructions to re-activate the device.