Dragino LDS02 Door Sensor

Owned by Rob Siegel
Nov 19, 2024
2 min read

 

 

Activation

When you receive the LDS02, please open the enclosure and add 2 x AAA batteries to power it. The LED will blink when device is powered. 

There may already be batteries in the unit with paper blocking their connection, please remove this paper if it is present.

Reset

In the event your device is offline or you need to reset it, please follow these steps.

  1. Open the sensor and remove the AAA batteries.

  2. Wait 10 seconds, then re-insert the AAA batteries and close the sensor.

Installation

There are 2 Options to physically install this sensor, with screws or with double-sided adhesive.

Installation with Screws:

Open the housing, install the screw through the reserved mounting hole, fix the bottom of the housing at the location to be detected, and then install the node body to the bottom housing.

ScrewsLDS.jpeg

Installation with double-sided adhesive

The double-sided glue is separated according to the cutting line and glued to the bottom of the LDS02 housing, and then the LDS02 is fixed at the location to be monitored.

 

When installing the LDS02 on a door, please make sure install as shown below so the arrows align closely to each other when the door is closed.

The space between the arrows must be less than 10mm.