Dragino LHT65N
- Alejandro Solorio (Unlicensed)
- Brent Meriwether (Unlicensed)
Activate
Press and hold the ‘ACT’ button until the green light flashes. The sensor will blink red-green-red once activated.
Reset Sensor
Press the ‘ACT’ button 5 times, the sensor will flash red. Next, press and hold the ‘ACT’ button until the green light flashes. The sensor will blink red-green-red once re-activated.
Replace Battery
When battery is low, replace the 3V battery.
Remove the two screws from the back of the sensor, remove the battery cover and replace the battery. Screw the battery cover back to the device. Activate the sensor once your new battery is inserted.
Temperature & Humidity Offsets
This is a new feature being rolled out to certain LHT65 templates.
Some of the new LHT65 Templates now support an Offset value for Temperature and Humidity values. This is an optional settings that you can use to “self calibrate” the values reported. It is useful in instances where for example you have multiple sensors in the same physical location, but the readings they receive differ.
Enter a value (positive or negative) to alter each value as it comes in.
