The following provides instructions on how to activate and install your Water Leak sensor after adding it to your account with an online gateway.

Installation Video

Drip Sensor

The top of the Leak Detector is shaped like a “sink” to direct the smallest amounts of water that drips from above to the Drip Sensor.
To use the Drip Sensor, place the Water Detector directly underneath drains, pipes, or anything else that might spring a leak
The cutout along the straight side of the Leak Detector allows the sensor to be placed along a wall, even with quarter-round molding

The bottom of the Leak Detector has three pairs of metal leads, that each act as separate sensors
To use the bottom sensors, place the Leak Detector on a at surface where you expect water to pool in the event of a leak

The Remote Sensor Probe has an extremely small form factor to fit underneath appliances and in other tight spaces
To use the Remote Sensor Probe, plug the 3.5mm plug into the jack on the Leak Detector, and place the Probe where you would like to monitor for water
The Probe can be placed on a surface or it can oat in a container (e.g. in a sump pump)
The Remote Sensor Probe can be used simultaneously with the Bottom Sensors and the Drip Sensor
The Leak Detector has magnets inside to optionally attach the Leak Detector to any magnetic surface while using the Remote Sensor Probe